Firevision consist of 256 flame head(16x16), like LED writing board, 400 x 357 cm Huge flashing and illuminate moving sign from side to side or schrolling. This system also support multi language. The Programmable fire display. Your Ad message to attract attention. Suitable for Big events or plazas.
SFX Fluid is name of colored flame fluid, which burns in color or red, green, blue, gold, purple and orange.SFX Fluid is alcohol based fluid so that it is very much flammable. It is miscible with water and burns clean with almost no smoke. SFX Fluid is highly flammable liquid and classified as dangerous goods for transportation by air or sea. For the air-shipment, SFX Fluid should be packed, labelled and inspected according to IATA rules and regulation.The maximum package size via air-shipment is 20L jerrican. For the sea-shipment, SFX Fluid should be packed in the jerricans or drums, which are certified by the authority. Also, the mixed shipment with other shippers to the same container of 20 foot or 40 foot is not allowed. Our colored flame is not visible during daylight becasue it has almost no glow while burning. So, during daylight, colored flame effect is not possible. The available colors of SFX fluid are Red, Green, Blue, Gold, Purple and Orange.
Fire Bird Flame System is designed for indoor use as well as for using at the wedding ceremony mainly.
This system can shoot approx. less than 1 meter flame and its fuel is butane gas canister(about 230gr).
3 butane gas canisters are installed inside the system(one is for pilot flame and the other two are for main flame). The main flame fuel canisters are warmed with heaters so that it can make the flame height approx. 2 meter
Dual Flame system can make a LPG flame up to 3m high. It has 2 flame jets.
One is for 3 m flame column or fireball and the other is 1m or lower flame ball.
Dual Flame System uses a spark to ignite the pilot flame. This pilot flame must be monitored by the rod flame sensor before big flames can be made. The system is controlled by standard DMX controller
Hurricane mini can fire your desired single colored flame or natural flame on demand.
Using our Colorfirefly SFX fluid for main flame or Isopar G or H for natural flame and compressed air as propellant, the system gives you the ability to shoot a flame approximately 5-6m(16-20ft) on average at working pressure 8 bar(116psi)
Known as the big brother from the regular Hurricane single flame system, this “Hurricane Giant” can produce only yellow flames up to 15 meter high in optimal conditions. The system consists of a small flame head and a fluid tank.
Inside the flame head, a small butane canister provides the gas for the pilot flame. Once the safety system detects the pilot flame, it’s possible to generate a big (color) flame column.
The 16 liter pressure tank is the flame fluid reservoir that will be pressurized by an external nitrogen gas cylinder to get the required pressure for the system.
Sunshine Single Colored Flame System can fire your desired single colored flame up to 8 -10m(26~33ft) high.
Using our Colorfirefly SFX fluid for colored flame effect or Isopar G or H for natural flame effect and Nitrogen Gas or compressed air as propellant , the system gives you the basic ability to shoot 1-5 pillars of a colored flame or natural flame approximately 8 ~ 10 m(26~33ft) at working pressure 2.0MPa(290psi) simultaneously.
Flame Fountain is the revolutionary product in the special effect industry.
This system shows two opposing elements coexistence of water and flame.
The system, which is a small fountain with a flame dancing atop the stream of cascading water, creates the paradoxical visual effect by dispelling a dose of natural gas through the water, making it flammable and able to emit a ball of fire at the center. Thus, there is the illusion of a cooperative relationship between the two natural elements
The “4 Flame head system” can fire a desired (color) flame up to 10 meter high in optimal conditions. The system consists of 4 small flame heads and one big fluid tank 30L. Inside the flame head, a small butane canister provides the gas for the pilot flame. Once the safety system detects the pilot flame, it’s possible to generate a big (color) flame column. The 30 liter capacity pressure tank is the (color) flame fluid reservoir
that will be pressurized by an external nitrogen gas cylinder to get the required pressure for the system and 4 flame heads are connected to this fluid tank with fluid hoses. The flame heads are truss-mountable.
The height of the flame depends on the nozzle and working pressure from the system. 1.5mm nozzle at 15 bar generates a flame of 5 - 6 meter high and 2 mm nozzle at 20 bar generates a flame of 8 - 10 meter high.
Moving Flame System can make a flame column up to 10m high. The system has a maximum movement of 360º for Pan and 180º for Tilt. System has 5 DMX channels (CH1-Pan, CH2-Tilt, CH3-Shoot, CH4-Spark, CH5-Spare). The pressure to shoot the flame up to 10m is supplied from nitrogen gas tank. The system is controlled by standard DMX controller. For Safety measure, the spark igniter is monitored with UV sensor and without spark, the system cannot shoot the flame
Volcano Flame System can shoot LPG flame pillar 2 ~ 3 meter high. The LPG gas tank(2KG, 4.5LBS) is housed inside the system so that there is no need to run gas hose from LPG gas tank. Just connect power code and DMX signal cable and operate.
Power Flames can make a propane fire ball up to 8 m (Power Flame I) or 12 m (Power Flame II) high. Inside the system a gas tank is installed and propane gas from an external gas cylinder is used to charge the Power Flame unit. It takes about 10 to 20 seconds for charging. The Power Flames uses a spark to ignite the pilot flame. This pilot flame must be monitored by the rod flame sensor before big flames can be made. The system is controlled by standard DMX controller.
Prism Flame System can fire a desired single color flame among four colors. Using color flame fluid that mixes with propane gas or nitrogen gas will generate a colored flame between 1.5 and 3 meter high, depending on the propellant gas. Up to four different color flame fluid bottles (900ml) can be housed inside Prism flame. For safety purpose, Prism Flame is equipped with a pilot flame detection (electrode) and its safeguard control board.
Power Flames can make a propane fire ball up to 8 m (Power Flame I) or 12 m (Power Flame II) high. Inside the system a gas tank is installed and propane gas from an external gas cylinder is used to charge the Power Flame unit. It takes about 10 to 20 seconds for charging. The Power Flames uses a spark to ignite the pilot flame. This pilot flame must be monitored by the rod flame sensor before big flames can be made. The system is controlled by standard DMX controller. (CUSTOM-MADE AVAILABLE)
Hurricane Multi Color Flame System can fire up to 4 different colors of flames up to 10 meter high in optimal conditions. The system consists of a small flame head and 4 fluid tanks. 4 nozzles are installed on the flame head. Inside the flame head, a small butane canister provides the gas for the pilot flame.
Once the safety system detects the pilot flame, it’s possible to generate a big (color) flame column.
The 4 x 11 liter capacity pressure tanks are the (color) flame fluid reservoirs that will be pressurized
by an external nitrogen gas cylinder to get the required pressure for the system.
The height of the flame depends on the nozzle and working pressure from the system.
1.5 mm nozzle at 15 bar generates a flame of 5 - 6 meter high and 2 mm nozzle at 20 bar generates a flame of 8 - 10 meter high.
Sunshine Single Colored Flame System can fire your desired single colored flame up to 8 -10m(26~33ft) high.
Using our Colorfirefly SFX fluid for colored flame effect or Isopar G or H for natural flame effect and Nitrogen Gas or compressed air as propellant , the system gives you the basic ability to shoot 1-5 pillars of a colored flame or natural flame approximately 8 ~ 10 m(26~33ft) at working pressure 2.0MPa(290psi) simultaneously.
COMMANDE
vide
